Baseline Systems FreeWave Ethernet Radio - Manual (Page 93)

LUM0024AB Rev A
Chapter 7: SNMP Settings
Use the simple network management protocol (SNMP) settings located in the SNMP tab or page to help
monitor the state of the transceiver for conditions that may warrant special attention.
Note: The information in this chapter assumes that you are familiar with SNMP and its
use in your site.
Each of the SNMP-manageable objects is also contained in the FREEWAVE-TECHNOLOGIES-MIB file that
you can use to import into your system. The basic object tree structure and a description of each element
available in that file is available in "Object Tree for FREEWAVE-TECHNOLOGIES-MIB" on page 125. The
file is available from FreeWave upon request.
Defining SNMP management conditions requires setting the following:
l
SNMP agent information - SNMP version and passwords.
l
Trap configuration - For example, the fault time and the IP address of the location that is
gathering the fault conditions.
l
Trap limits - The high and low limits after which a fault occurs.
SNMP Parameter Reference
This section contains the following information as it applies to the SNMP parameters that you can set for the
transceivers described in this document.
parameter name (as you see it in Tool Suite)
Web Parameter: The name of the field as it appears in the configuration Web pages.
Network Type: Point-to-Point, Point-to-MultiPoint, or Both
Default Setting: The factory default setting for the parameter.
77