6 preset tare (keyed tare), 7 display tare, 8 print ticket – Rice Lake 480 Legend Series Digital Weight Indicator Installation Manual User Manual
Page 11: 9 toggle gross/net mode, 10 view audit trail, Preset tare (keyed tare), Display tare, Print ticket, Toggle gross/net mode, View audit trail
Introduction
7
1.5.6
Preset Tare (Keyed Tare)
1. With the scale empty and display showing zero weight, press
.
2. Display will show (000000); the focused digit will flash.
3. To edit the value:
• Press or to select the digit.
• Press or to increment or decrement the value.
• Press
when the value is correct.
4. The display will change to the Net mode and the PT LED lights to show the preset tare was entered.
1.5.7
Display Tare
When a stored Tare value is displayed, the Gross and Net LEDs will be off and the
will be lit. To display a
stored tare:
1. Press .
2. Press
to
AUDIT.
3. Press
to
TARE
and press .
4. Press repeatedly to return to weighing mode.
If there is no tare in the system, the value displayed will be zero and the Gross and Net LED will be turned off.
See Section 9.12 for more information pertaining to the regulatory mode of operation.
1.5.8
Print Ticket
1. Press
to print either the Gross or Net format. When the accumulator is enabled and displayed, it is
used to print the accumulated value.
2. Wait for
LED to light.
3. Press
to send data to the serial port.
If
LED is not lit and the
key is pressed, the print action will take place only if the scale comes out
of motion within 3 seconds. If the scale stays in motion for over 3 seconds, the PRINT key press is ignored.
1.5.9
Toggle Gross/Net Mode
1. Press
to switch the display mode between gross and net. If a tare value has been entered or
acquired, the net value is the gross weight minus the tare.
Gross mode —
Gross/Brutto
LED is lit.
Net mode —
Net
LED is lit.
1.5.10 View Audit Trail
1. Press .
2. Press
to
AUDIT.
3. Press . The audit trail CALIB is displayed.
4. Press then or to CNT, TIME or DATE.
5. Press to view selected parameter.
6. Press twice to return to CALIB.
7. Press to the audit trail CONFIG and repeat steps 5 and 6 to view configuration number.
8. Press repeatedly to return to weighing mode.
TARE
TARE
MENU
GROSS
NET
B/N
MENU