Rice Lake 480 Legend Series Digital Weight Indicator Installation Manual - Manual (Page 50)

46 480 Operator’s Manual
6.1.6 Normal Mode Commands
The serial transmit weight data commands (see Table 6-12) transmit data to the selected port on demand. The SX
and EX commands are valid only in normal operating mode; all other commands are valid in either setup or normal
mode.
Command Description Values
GFMT Gross demand print format
string GROSS<G><NL2><TD><NL>
NFMT Net demand print format string GROSS<G><NL>TARE<SP><T><NL>NET<SP2><N>
<NL2><TD><NL>
ACCFMT Accumulator demand print
format string ACCUM <A><NL><DA> <TI><NL>
SPFMT Setpoint print format <SCV><SP><SPM><NL>
Table 6-11. PFORMT EDP Commands
Command Description Response Format
UID View and set unit ID when in setup mode.
View only in normal mode. nnnnnnn
DATESET View and set date when in setup mode.
View only in normal mode. MMDDYY, DDMMYY, YYMMDD, YYDDMM (enter using
DATEFMT specified)
TIMESET View and set time when in setup mode.
View only in normal mode. hhmm (enter using 24-hour format)
SX Start streaming on Port 2.
The Trigger Mode of Port 2 must
be set to one of the four stream
modes for this command to
function.
OK or ??
EX Stop streaming on Port 2
The Trigger Mode of Port 2 must
be set to one of the four stream
modes for this command to
function.
OK or ??
RS Soft reboot —
XA Transmit accumulator value nnnnnn UU
Where nnnnnn is the weight value, UU is the units.
XG Transmit gross weight in displayed units
XN Transmit net weight in displayed units
XT Transmit tare weight in displayed units
XG2 Transmit gross weight in non-displayed units
XN2 Transmit net weight in non-displayed units
XT2 Transmit tare weight in non-displayed units
XE Query system error conditions nnnnn nnnnn
See Section 9.0 for detailed information about the XE
command response format.
Table 6-12. Normal Mode Commands
Note
Note