Rice Lake 480 Legend Series Digital Weight Indicator Installation Manual - Manual (Page 13)

Introduction 9
1.5.14 Display, Edit and Set Setpoint Value
(Also see Section 8.0.)
1. Press .
2. Press to AUDIT.
3. Press until display reads SETPNT .
4. Press and navigate across to desired setpoint number (1-8).
5. Press and navigate across to select User.
6. Press and navigate across to select Enable, Value, PreAct or Hysteresis.
7. Press to view and edit the value.
• To edit Value, PreAct or Hyster:
- Press or to select the digit.
- Press or to increment or decrement the value.
- Press when the value is correct.
• To edit ENABLE :
- Press or to select ON/OFF.
- Press when the value is correct.
8. Press repeatedly to return to weighing mode.
See Section 3.2.1 for the SETPNT menu layout.
1.5.15 View Version
1. Press .
2. Press . AUDIT is displayed.
3. Press until display reads VERS.
4. Press . FIRMW is displayed.
5. Press to view version.
6. Press repeatedly to return to weighing mode.
1.5.16 Enter User Password
1. Remove the large fillister head screw from the back of the enclosure.
2. Insert a nonconductive tool into the access hole and press the configuration switch. Indicator display changes
to show CONFIG.
3. Press or until PASWRD is displayed.
4. Press . CNFG is displayed.
5. Press to USER.
6. Press . 000000 is displayed.
7. To edit the password:
• Press or to select the digit.
• Press or to increment or decrement the value.
• Press when the value is correct.
8. Press to return to PASWRD.
9. Press to CONFIG.
10. Press to return to weighing mode.
When entering a user function, the operator will now be required to enter the password.
Enter 999999 to reset password, this will also reset the configuration back to default values.
MENU
TARE
TARE
MENU
TARE
Important