Rice Lake 480 Legend Series Digital Weight Indicator Installation Manual - Manual (Page 24)

20 480 Operator’s Manual
3.2.1 Setpoint Menu
For more information see Section 8.0.
Figure 3-5. Setpoint Setup Menu
SETPNT Setup Menu
Parameter Choices Description
SETPT1
SETPT2
SETPT3
SETPT4
SETPT5
SETPT6
SETPT7
SETPT8 USER
SUPVSR
Setpoint options that do not require a user password.
Setpoint options that require a user password.
BATCH OFF
AUTO
MANUAL Set to OFF batching is disabled. Set to AUTO or MANUAL to allow a batch sequence to run.
MANUAL requires a BATSTRT digital input or BATSTART serial command before the batch
sequence can run. AUTO allows batch sequences to repeat continuously.
Setpoint submenus
USER VALUE
ENABLE
PREACT
HYSTER Allows user to enter setpoint values.
User submenus
VALUE number Display and edit the setpoint target value.
• For weight-based setpoints: specifies the target weight value, 0 – 999999.
• For time-based setpoints (delay): specifies, in 0.1-second intervals, a time value in the
range 0 – 65535.
ENABLE OFF
ON Enable or disable the setpoint.
PREACT number Allows a setpoint to shut off before the setpoint is satisfied to allow for material in
suspension.
HYSTER number Specifies a band around the setpoint value that must be exceeded before the setpoint, once
off, can trip on.
Table 3-2. Setpoint Setup Menu Parameters
MENU
TIMDAT ACCUM SERIAL SETPNT
MANUAL
OFF
AUTO
PFRMAT
... ...
BATCHG SETPT1-8
USER
000000
VALUE
000000
PREACT
000000
HYSTER
OFF
ON
ENABLE
SUPVSR
PUSHPR
OFF
ON
PUSHAC
OFF
ON
PUSHTR
OFF
ON
DIGOUT
NONE
1-8
BATSEQ
OFF
ON
KIND
OFF
GROSS
NET
-GROSS
-NET
DELAY
TRIP
HIGHER
LOWER
OFF
ON
WAITSS