Rice Lake 480 Legend Series Digital Weight Indicator Installation Manual - Manual (Page 27)

Configuration 23
SERIAL Menu
Parameter Choices Description
COM-1 TRIGER
BAUD
BITS
SBITS
TERMIN
EOLDLY
ECHO
PRNMSG Specifies settings for COM-1.
COM-2 TRIGER
BAUD
BITS
SBITS
TERMIN
EOLDLY
ECHO
PRNMSG
STRUR Specifies settings for COM-2.
DEVMOD Specifies the operating mode of the indicator. See Section 9.4 on page 54.
In local/remote mode, the remote indicator will display a FAILED message
when an OK message was not received after a predefined timeout.
NONE Port is a nonstreaming demand port.
LOCAL A LOCAL indicator streams a continuous flow of weight data according to a specified
format. Type of data streamed is selected under Port 2 TRIGER.
REMOTE A REMOTE indicator echoes a stream of data from the serial port to the display and also
echoes key pressing to the serial port.
Submenus COM-1 and COM-2
TRIGER
(COM-1) Specifies the ports mechanism for triggering a transmission of data.
DEMAND Demand port – the indicator is not in local/remote mode. Printing will take place only when
the Print key is pressed or the KPRINT EDP command is received.
PRN Port is set as printer.
NONE Port is inactive.
COMAND Command port – allows operation of EDP commands, but will not print from this port.
(Selecting DEMAND accepts commands and prints). The indicator is not in local/remote
mode.
TRIGER
(COM-2) NONE Port is inactive.
STR1 Port is used to transmit a continuous flow of information according to consolidated stream
format.**
STR2 Port is used to transmit a continuous flow of information according to Toledo8142 stream
format.**
STR3 Port is used to transmit a continuous flow of information according to Cardinal738 stream
format.**
STR4 Port is used to transmit a continuous flow of information according to Weightronix WI-120
stream format.**
**DEVMOD must be set to local to enable streaming.
PRN Port is set as printer.
BAUD 1200
2400
4800
9600
19200
38400 Baud rate. Selects the transmission speed of data.
BITS 8NONE
7EVEN
7ODD Selects number of data bits and parity of data.
Table 3-4. Serial Menu Parameters
Note