Rice Lake 480 Legend Series Digital Weight Indicator Installation Manual - Manual (Page 48)

44 480 Operator’s Manual
Command Description Values
SC.PRI.DECPNT Primary units decimal position 8.88888, 88.8888, 888.888, 8888.88, 88888.8, 888888
SC.PRI.DSPDIV Primary units display divisions 1D, 2D, 5D, 10D, 20D , 50D
SC.PRI.UNITS Primary units LB, KG, OZ, TN, T, G
SC.SEC.DECPNT Secondary units decimal position 8.88888, 88.8888, 888.888, 8888.88, 88888.8, 888888
SC.SEC.DSPDIV Secondary units display divisions 1D, 2D, 5D, 10D, 20D , 50D
SC.SEC.UNITS Secondary units LB, KG, OZ, TN, T, G
Table 6-4. FORMAT EDP Commands
Command Description Values
SC.WZERO Zero calibration —
SC.WVAL Test weight value value
SC.WSPAN Span calibration —
SC.REZERO Rezero —
SC.LC.CD Read or set dead load counts value
SC.LC.CW Read or set span counts value
Table 6-5. CALIBR EDP Commands
Command Description Values
PWRUPMD Power up mode GO, DELAY
REGULAT Regulatory compliance NTEP, OIML, CANADA, INDUST
CONSNUM Consecutive number 0 – 999999
CONSTUP Consecutive number start-up value 0 – 999999
ACCUM Accumulator ON/OFF
ACCUM.RTZGRADS Return to zero trigger 0 – 10000 GRADS
DATEFMT Date format MMDDYY, DDMMYY, YYMMDD, YYDDMM
DATESEP Date separator SLASH, DASH, SEMI
TIMEFMT Time format 12HOUR, 24HOUR
TIMESEP Time separator COLON, COMMA
UID Unit ID Value 0 – 999999
POWER Power switch mode AUTO, MANUAL
Table 6-6. PROGRM EDP Commands
Command Description Values
DIGIN1
DIGIN2
DIGIN3
DIGIN4 Digital input function OFF, ZERO, TARE, NT-GRS, UNITS, DSPTAR, PRINT, CLRCN,
KBDLOC, HOLD, CLRTAR, ACCUM, CLRACC, BATSTR, BATSTP,
BATRES, BATPUS, BATRUN, K0-9, KENTER, KDOT, NET, GROSS,
PRI, SEC
Table 6-7. DIG IN EDP Commands