Rice Lake 480 Legend Series Digital Weight Indicator Installation Manual - Manual (Page 30)

26 480 Operator’s Manual
3.3 Configuration Using the Front Panel (Legal for Trade)
The 480 indicator can be configured using a series of menus accessed through the indicator front panel when the
indicator is in configuration mode.
When the indicator is placed in configuration mode, CONFIG is shown on the display. The CONFIG menu is the
first of eight main menus used to configure the indicator. Detailed descriptions of these menus are given in
Section 3.3.1 on page 27. When configuration is complete, return to
CONFIG and press the ( ZERO ) key to exit
configuration mode and save changes. Then replace the configuration switch access screw.
To place the indicator into the configuration mode, a configuration switch is accessed by removing the large
fillister head screw on the enclosure back. Switch is activated by inserting a nonconductive tool into the access hole
after pressing the menu switch.
1. Remove setup switch access screw from back of indicator.
2. Using a nonconductive tool, press the button located in the access hole. This allows access to configuration
menus.
Menu
Required
Password* Menu Function
CONFIG Configuration Config Graduations (scale capacity), Configure zero tracking, zero range, motion
band, overload, tare function, sample rate, and digital filtering parameters.
FORMAT Format Config Set primary and secondary units.
CALIBR Calibration Config Calibrate indicator. See Section 4.0 on page 37 for calibration procedures.
PROGRM Program Config Set power-up mode, regulatory mode, and consecutive number values.
DIG IN Digital Input User Assign digital input functions. Used only if the Relay option is installed.
ALGOUT Analog Output Config Configure analog output module. Used only if analog output option is
installed.
PASWRD Password Config Enable and edit configuration and user passwords.
TEST Test Config Test A/D, Test and set Digital I/O, reset indicator to default settings, set over
and under weighment characteristics.
MENU Menu User Non Legal-for-Trade settings, such as Audit Trail, view Tare, set Unit ID, view/
print Accumulator,set Time/Date, and Non Legal for Trade setting for Serial
Port, Setpoints, and Print Format parameters. See Section 3.2.
Can be accessed without pressing the Setup Switch by
pressing the MENU key on the front panel.
* Password required for all menus if a password for that level has been entered. See Section 3.3.7.
Table 3-6. 480 Menu Summary
Note