Rice Lake Explorer Series Toploader, Ohaus - Manual (Page 140)

EN-138 EXPLORER BALANCES
TABLE 9-10. EXPLORER INTERFACE COMMAND LIST (continued)
Command
Characters
1)
Function
PSN Print Serial Number.
PV Print base software version, terminal software version and LFT ON (if LFT is set ON).
x# Set Counting APW (x) in grams. (must have APW stored)
P# Print Counting application APW.
x% Set Percent application reference weight (x) in grams. (must have reference weight stored)
P% Print Percent application reference weight.
xAW Set Dynamic Weigh Level to x. (x = 1 - 99 seconds)
xAW Set Dynamic Weigh Mode. x = A (Automatic), S (Semi-Automatic), M (Manual)
PAW Print Dynamic Weigh Level.
BAW Start Dynamic Weigh cycle. (Manual Mode)
CW Clear locked weight (weight < threshold) in Dynamic Weigh (same as button “Reset”) & Display
Hold (same as button “End Peak Hold”).
xCO Set Checkweighing Over Limit in grams x.
xCU Set Checkweighing Under Limit in grams x.
PCO Print Checkweighing Over Limit.
PCU Print Checkweighing Under Limit.
xCM Set Checkweigh mode (1=over/under, 2=target/% tolerance, 3=Target/weight tolerance
xCT% Set Checkweighing target in grams x for percent tolerance mode.
PCT% Print Checkweighing Target for percent tolerance mode.
xCTW Set Checkweighing target in grams x for weight tolerance mode.
PCTW Print Checkweighing Target for weight tolerance mode.
xC% Set Checkweighing % tolerance x. Attention: when x is a positive value, it is used to set the
+tolerance value; vice versa.
PC% Print Checkweighing % tolerance.
xCW Set Checkweighing weight tolerance x. Attention: when x is a positive value, it is used to set
the +tolerance value; vice versa.
PCW Print Checkweighing weight tolerance.
xDH Set Display Hold mode (Peak Hold). x = A (Automatic), S (Semi-Automatic), M (Manual)
xD Set 1 second print delay (set x = 0 for OFF, or x = 1 for ON).
xFL Set filter level to x (1 = low, 2 = med, 3 = high).
xAL Set Auto-zero to x (x = 1 for 0d, x = 2 for 0.5d, x = 3 for 1d, x = 4 for 3d).
Esc R Resets all Balance menus to factory defaults. Attention: The binary code of this commands is
“1B 20 52 0D 0A” or “1B 52 0D 0A”.
PID Print current user Name.
xID Program user Name. Attention: only allowed numeric input.
xTL Set Totalize Mode. x = A (Automatic), M (Manual).
PTIME Print current time.
PDATE Print current date.
xTIME Set Time, x format: hh:mm:ss.
xDATE Set Date, x format: mm/dd/yyyy.
CA Continuous weight, same as CP.
SA Stable load, same as SLP.
xA Interval Print x = interval in sec (1-3600) 0 = off, same as xP.
0A Set AutoPrint off, same as 0P.
SC Begin Span Cal, same as C.
xAM Set Animal Mode to Auto, Semi-Auto, Manual. Same as xAW(A/S/M)
? Prints current mode, same as PM.
xS 0 = print unstable data, same as IP; 1 = print stable only 1) , same as SP.
xRL 0 = disable response; 1 = enable response. This command only controls the “OK!” response.