Rice Lake Explorer Series Toploader, Ohaus - Manual (Page 143)

EXPLORER BALANCES EN-141
Balance Setup FOR USB INTERFACE
A) The Ohaus Interface is preset to communicate using the following settings:
2400 baud, 7 bit, no parity, no handshake.
To use different settings, it will be necessary to change either the balance settings, or the computer settings.
B) Configure the balance to the desired USB and printing parameters.
PRINT
Stable
On, Off
A-Print
Cont, On.Stbl, On.Acc*, 5sec, 15sec, 30sec,
60sec, off
End
Yes, No
*Note: Print and USB menu selections may
vary between the different balance series.
USB
USB
On / Off
Baud
600, 1200, 2400, 4800, 9600, 19200
Parity
7-even, 7-odd, 7-none, 8-none
Handshake
None, Xon-Xoff, RTS-CTS
END
Yes, No
SETUP DEFINITIONS
PRINT / Stable – On
Balance transmits stable data only.
PRINT / Auto Print – Continuous Balance repeatedly sends data as fast as possible.
PRINT / Auto Print – On Stable Balance automatically outputs data upon stability.
PRINT / Auto Print – (xx) sec Balance sends data every (xx) seconds.
PRINT / Auto Print – Off Only sends data when PRINT is pressed.
USB / USB – Off Turns Interface off, saving battery power.
USB / Baud, Parity, Handshake Set parameters to match printer or computer.
Operation
USB OUTPUT
With the Adapter installed the balance will operate in one of the following three ways:
• USB = On, Auto Print = Off, Stable = On or Off
Press PRINT to send the display data based on the settings in the Menu.
If Stable is set to On, the balance will wait for a stable reading before sending data.
• USB = On, Auto Print = On, Stable = On or Off
The balance will automatically send data.
If Stable is set to On, only stable values will be sent.
• USB = Off
The interface is turned off.