Rice Lake MSI4300 PortaWeigh Plus Crane Scale 7 Key - Manual (Page 13)

Page 12 MSI-4300 Porta-Weigh Plus/7 Key • User Guide
M E A S U R E M E N T S Y S T E M S I N T E R N A T I O N A L
To remove the Tare Value:
Without erasing the value, push NET/GROSS. The Tare will remain
in memory until a new tare value is stored.
Note: A factory option is available that will erase the Tare by pushing
the TARE key when the weight is at zero.
TOTAL
Function:
For accumulation of multiple weighments. The accumulator always
uses the displayed weight, so Gross and Net readings can be added
into the same total. There are two modes of Totalizing which are set in
the Calibration SETUP section. The Manual mode requires that the
TOTAL key is pushed when the weight currently on the scale should
be added to the previously accumulated value. The Auto mode will
automatically add the last, settled, stable, value to the total. Both
modes require that the weight on the scale returns within 1% (relative
to full scale) of Gross Zero or Net Zero before the next weighing can
be added. Applied weight must be 2% of full scale or “Min e”
(whichever is greater) above Gross Zero or Net Zero before it can be
totaled.
Manual Total:
Use:
1) The motion annunciator must be off, the scale must be stable
±
1 division. If there is considerable motion on the scale, use
the Medium or High Filter setting (see SETUP).
2) Only positive readings can be accumulated.
3) After a weighment is totaled, the weight on the scale must
return to below 1% of full scale capacity relative to Gross
Zero or Net Zero before another weight can be added to the
total. This assures that a weight on the scale is only added to
the total once.
4) When the total weight exceeds the display capability of
999,999 counts, or the total count exceeds 9999, dashes will