Rice Lake MSI4300 PortaWeigh Plus Crane Scale 7 Key - Manual (Page 30)

MSI-4300 Porta-Weigh Plus/7 Key • User Guide Page 29
M E A S U R E M E N T S Y S T E M S I N T E R N A T I O N A L
leading zeros.
Note: With Remote Control option, the Tare value can be
entered directly from the numeric keypad. Skip to step 6.
4) Use the SELECT key to change the flashing digit. When the
desired digit is displayed, push ENTER .
5) Repeat step 4 for the remaining digits.
6) When the last digit is entered the ENTER key is pushed again
to return to the Tare Memory menu, or the CLEAR key can
be used to delete the entire value and start over.
7) At this point the TARE key can be pushed to immediately
apply the new tare or the SELECT key can be used to select
another Tare Memory for entry or modification.
To delete a stored tare value:
Note: This procedure is not usually necessary because a new tare
value can always be stored over an old value or the undesired value
can just be ignored. Some situations using the ID Number function
(See Infrared Remote section) may require that a tare value be deleted.
Also to disable the NET/GROSS operation the selected Tare must be
deleted.
1) Push SHIFT TARE MEMORY.
The message provides the value of the first Tare Memory in
the form of “TARE x”. Use the SELECT key to scroll to the
Tare Memory number/value that you wish to delete.
2) Push ENTER. Push SELECT. The numerics show the current
stored tare value with the left-most digit flashing.
3) Push CLEAR (no Shift required). The value will be elimi-
nated and the memory location will indicate “0” on the
numeric digits.
Note: The entire value will clear only if the left most digit is
flashing. The Clear key will backstep delete any other digit.
4) A new Tare Memory can now be applied as described
previously. To return to normal scale operation without
applying a Tare, scroll using the SELECT key until the
message reads “EXIT?” and push ENTER, or push the
CLEAR key.
CLEAR
Function:
Used to clear numeric values and calculated values and to exit from