Rice Lake MSI-4260 Port-A-Weigh - Manual (Page 53)

10) Press USER key until the desired
print control mode is shown.
11) When the desired print mode is
shown, push TARE to save. The
next Print setup item, “rAte”
appears. If you have set
Continuous (Cont) as your print
control, proceed to step 12). For
any other Control mode jump to
step 15.
12)Press TARE to enter the Print
rate number entry screen. The
current print rate appears on the
LCD.
In this example, we’ll set the Print Rate
to an output rate of once every 2
seconds.
/R$G &RQW
Function Key Prints Print is disabled
UDWH
Next Print Menu Item
TARE
T
USER
F
USER
F

blinking
Example Value
The number represents the print
interval rate in seconds. Use 0 for the
fastest the MSI-8000 can go (~5 times
per second). To set a once a minute
transmission, set the rate to 60. To
set once per hour, set the rate to 3600, etc. Largest possible
entry is 65535 which is >18 hours.
TARE
T
13) Press USER to change the Print
rate. Scroll the number with the
USER key. Enter each number
with the TARE key.
14) When the entire number is
displayed, press TARE again to
finalize the seconds entry. The
next Print Menu Item appears,
“String”.
15) Exit the Print Setup Menu by
pressing ZERO twice. The
message “Store” appears briefly
then normal system operation
starts.

blinking

blinking

fixed
6WUQ
3ULQW 6WRUH
USER
F
ZERO
O
sto
ZERO
O
sto
TARE
T
TARE
T
USER
F
RF Remote Display Option 49
Figure 7-3. Printer Output Menu (continued)