Rice Lake MSI-4260 Port-A-Weigh - Manual (Page 55)

2Q2II
2Q
3ULQW
RF Setup Procedure
VFLG
U)

example ScID Value
 

fixed
blinking blinking
Error Correction: If you input a wrong value, press ZERO to step
back one digit and reenter.
&KQ/
USER
F
TARE
T
TARE
T
TARE
T
TARE
T
TARE
T
TARE
T
TARE
T
1) With the power on, open the
Comm Setup Menu by
pressing the
TARE and
USER keys simultaneously.
The COMM Setup Menu
appears. The first menu
choice is “Print”.
2) Press USER to scroll to the
RF Setup menus.
3) Press TARE to enter the RF
setup menu.
4) The display reads “OnOff”
Confirm the 8000 RF is on
by pressing
TARE . If it is off,
use the USER key to change
it to on. Then push TARE .
Off is only used when the 8000 is
hardwired to a Dyna-Link.
5) Press TARE . Next the “Scid”
(ScaleCore ID) screen is
shown
6) Press TARE . The current
Scid number is shown.
If the offered Scid value is correct,
push TARE and jump to step 10.
In this example we’ll enter 3 as an SCID
number. Any value from 1-254 is
acceptable. However, MSI
recommends a value from 20 – 30.
7) To input the SCID value,
press
USER to start the
number entry process..
8) Use USER to change the
number, and TARE to
enter the number. Add the
next digit by pushing
USER and scrolling as
required. Repeat this
sequence until the entire
SCID number is entered.
9) Once the entire SCID
value is entered, press
TARE to finalize the
number.
10) The next RF Setup
parameter is “ChnL”
(Channel). Press
TARE to
start the number entry
process.
USER
F
USER
F
Press Simultaneously
TARE
T
USER
F
RF Remote Display Option 51
Figure 7-5. RF Setup Menu