Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 12)

Introduction 9
6. Route the media through the printer as shown. Raise the media guide. The media guide should be pushed
inward so that it is just touching the edge of the media.
Figure 1-17. Routing Media Through Printer
7. Close the printhead assembly and press down until it locks into place.
8. Close the cover and press the FEED button several times to position the media and ensure proper
tracking. If the printer does not correctly sense the top of each label, it may be necessary to calibrate the
printer.
Figure 1-18. Printhead Assembly
1. Roll Media
2. Media Hanger Guide
3. Media Sensor
4. Media Guide
1. Printhead Assembly