Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 37)

34 SST3 Installation Manual
5.1.1 Heater Fuse Replacement
The Hoffman heater has a fuse that could possibly need replacing. Use the following steps to replace the fuse.
1. Using a slotted screwdriver, push against the fuse holder cover and turn at the same time. This will
dislodge the fuse from the receptacle.
Figure 5-18. Push and Turn Fuse Receptacle to Remove
2. Pull the actual fuse from the receptacle and replace with a new fuse.
Figure 5-19. Remove Actual Fuse From the Receptacle and Replace with a New Fuse
3. Reverse the removal steps to re-install the fuse holder cover.
5.2 Wireless Antenna Kit
Use the following procedure to install the wireless antenna option on the SST3 Printer.
This kit contains the following items:
• Communication Card (PN 103373)
• Antenna
• Ribbon Cable
• Standoffs
The following list of tools is required to install the wireless antenna option:
• #2 Phillips head screwdriver
• 7/16" Socket
• 9/32" Socket
Fuse location on heater Push and turn to remove fuse