Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 39)

36 SST3 Installation Manual
5.2.2 Install the Communication Card
1. Insert the two supplied standoffs into the printer’s main board as shown using a gentle twisting motion
on standoff, being careful not to damage board during assembly.
Figure 5-22. Insert Standoffs On Main Board
2. Slide the communication card into the rear of the printer. Align the two holes in the communication card
with the two previously installed standoffs.
Figure 5-23. Align Communication Card to Installed Standoffs.
3. Press the communication card carefully onto each of the standoffs until standoff secures card in place.
4. Install the two previously removed cover plate screws.
With t-shaped
end out as
shown, insert the
two standoffs on
the main board
Align card
to installed
standoffs