Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 41)

38 SST3 Installation Manual
3. Remove split communications cable plates by pushing with fingers up through the bottom access hole
from the underside to dislodge the split communications cable plates. Catch bolts if they fall through. Set
aside.
Figure 5-26. Remove the Component Parts of the Split Communications Cable Assembly
4. The split communications cable plate is made up of several individual pieces that are shown in Figure
5-27.
Figure 5-27. Component Pieces
5. Remove the four bolts from the printer case. These bolts can be saved or discarded.
Figure 5-28. Four Bolts Removed
Clamp plate
Half clamp
plate
S p l i t
communications
cable main plate
O-ring
Split seal
plates
S e a l
plug
L a r g e &
small split
s e a l
gromment