Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 40)

Options 37
5. Install each end of the supplied ribbon cable into its corresponding connectors on the printer’s main
board and communication card. Use care to prevent damage to either board during cable assembly.
Figure 5-24. Install Ribbon Cable
6. Re-install the printer’s cover and associated screws.
5.2.3 Install the Antenna
1. Using a 7/16” socket, remove the four nuts holding the split communications cable plate in place. Take
care in removing the nuts as they could slip and fall down between the plate and the printer enclosure.
Set the nuts aside.
Figure 5-25. Split Communications Cable Assembly in the SST3 Printer Enclosure
2. Pull the SST3 enclosure forward so that it hangs slightly off of table edge to allow access to the bottom
access hole.
Four nuts