Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 32)

Options 29
3. Using a 3/8” socket, carefully remove the four nuts that are holding the printer pad to the printer base
plate in the SST3 enclosure and set nuts aside.
Figure 5-5. Unscrew Four Nuts Holding Printer Pad to Printer Base Plate
4. Gently pull the printer and printer pad off the printer base plate mounting studs and set aside. The printer
base plate is now exposed.
Figure 5-6. Pull Printer and Mounting Pad Off Base Plate
5. Remove the upper nut on the power cord cover.
Figure 5-7. Remove Upper Nut of the Power Cord Cover Assembly
Use 3/8” socket to remove
four nuts on printer pad
R e m o v e t h e n u t
from the power cord
cover and set aside.
Second heater mounting
stud
Remove nut and set
aside