Rice Lake SURVIVOR SST3 Washdown Printer User Manual
Page 43
40
SST3 Installation Manual
8. Ensure the rubber gasket is seated properly around the bolts in the SST3 printer enclosure.
Figure 5-31. Press Down Rubber Gasket Around Bolts
9. Set the main plate over the four studs with recesses around the four holes located downward and press
down.
Note: Ensure that the split communications cable main plate is oriented so that the tapered side is facing up as shown in Figure
5-32, right image. An easy way to tell if the main plate is oriented correctly is to note that the four holes on the main plate have
counter bores which should face down. Refer to Figure 5-32.
Figure 5-32. Incorrect and Correct Orientation of Main Plate
10. Push the entire SST3 enclosure unit back onto the table or other sturdy work surface.
E n s u r e t h a t
the larger side
of the tapered
p o c k e t i s
f a c i n g
upwards when
pl ac ing it on
the four studs
Note counter
bore