Rice Lake SURVIVOR SST3 Washdown Printer User Manual
Page 35
32
SST3 Installation Manual
11. Making sure the plastic spacers are in place, put the clear plastic terminal strip cover on top of the
terminal strip and using just the 5/16” socket, tighten the two nuts. This should be done by hand to snug
the nuts. Over tightening can crack the clear plastic cover.
Figure 5-13. Replace Clear Plastic Cover and Gently Tighten
12. Gently peel off adhesive backing from the three square cable ties. The location of placement of the
square cable ties are noted on the bottom of the SST3 enclosure. Press the square cable ties firmly onto
the enclosure bottom where noted.
Figure 5-14. Secure Square Adhesive Cable Ties to SST3 Enclosure Bottom
13. Set the printer unit back down onto the printer base plate, lining up the four metal studs. Also ensure the
ribbon cable at the front of the printer is also out of the way when placing the printer back into the
enclosure. Note the ground wire location leading to the front of the SST3 enclosure. The wires should
run between the side of the SST3 enclosure and the metal standoff. By doing so, will eliminate the risk of
wires being pinched.
Figure 5-15. Don’t Pinch Ground Wire
Plastic spacers x 2
Template location for square adhesive cable ties
Remove backing paper