Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 44)

Options 41
11. Assemble the split seal plates back together with the cable in between (Figure 5-33, left image).
Note: Run finger across the split seal plates to ensure there is no dirt or oil on the surface prior to joining the two surfaces
together.
Note: Make sure the larger diameter hole side is facing upwards as you put the two pieces together.
Figure 5-33. Assemble The Split Seal Plates Together
12. Place the O-ring over the cable end and into the groove around the split seal plates (Figure 5-33, right
image). This will hold the plates together and also offer a watertight barrier.
13. Connect the communications plug to the appropriate connection on the back of the printer.
Figure 5-34. Connect the Communications Cable to the Back of the Printer
14. Carefully push the whole split seal assembly down into the printer enclosure as shown below.
Figure 5-35. Seat the Split Seal Assembly