Rice Lake SURVIVOR SST3 Washdown Printer User Manual
Page 17
14
SST3 Installation Manual
8. Route the backing material under the assist roller and around the internal rewinder as shown below.
Figure 1-27. Route Backing Material Under Assist Roller
9. Put the leading edge of the backing material into a slot on the internal rewinder and insert the media clip.
Be sure the leading edge of the backing material is cut square and that is inserted evenly into the slot.
Figure 1-28. Place Backing Material onto Internal Rewinder
10. Manually rotate the internal rewinder to remove slack from the backing material.
Figure 1-29. Flip Mechanisms Back Down to Secure Labels
11. Flip the holding mechanisms down to secure the labels as shown in Figure 1-29.
12. Plug in and turn “on” the printer. After initialization, press the
FEED
button to align the next label to the
top of form position. (If a peeled label is presented, remove it to proceed). The printer is now ready for
on-demand use.