Rice Lake SURVIVOR SST3 Washdown Printer User Manual
Page 31
Advertising
28
SST3 Installation Manual
The heater kit comes with the following parts.
Figure 5-3. SST3 Printer Heater Kit Component Parts.
Use the following steps and photos to install or replace the heater.
1. Unplug power to the unit.
2. Disconnect any cables such as the power cord and the communications cable located on the back of the
printer, and the ribbon cable located at the front of the printer.
Figure 5-4. Disconnect Power and Printer Cables
H o ff m a n h e a t e r, f u s e ,
mounting bracket and
wire harness
Nut (qty. 1)
Power cord
Advertising