Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 13)

10 SST3 Installation Manual
Loading Optional Ribbon into the Printer
1. Make sure printer is sitting on a horizontal surface.
2. Open printer cover by unlocking the hinged latches that are located on both sides of the unit and lifting
the cover to the front of the unit.
3. Press in on the printhead latch and raise the printhead assembly.
Figure 1-19. Open Printhead Latch to Load Optional Ribbon
4. Wrap the ribbon around the ribbon hub and rotate the ribbon take up shaft several times to take up all the
slack and remove any wrinkles in the ribbon.
Figure 1-20. Wrap Ribbon Around Ribbon Spool
1. Printhead Latch
I n k S i d e ( C S O
ribbon)
Ink Side (CSI ribbon)