2 washdown procedure, Warning – Rice Lake SURVIVOR SST3 Washdown Printer User Manual
Page 19
16
SST3 Installation Manual
1.2
Washdown Procedure
The following instructions must be followed explicitly. Failure to follow these
instructions will result in damage to the contents inside enclosure and/or create a hazardous
condition.
This section describes the general procedure for washdown applications.
1. Unplug power to the printer.
2. Securely latch the main latches on the side of the enclosure.
Figure 1-31. Secure Main Latches
3. Ensure that the label presentation chute cover is securely closed. The label cover tab will be tightened
securely against retaining washer and mounting block.
Figure 1-32. Presentation Chute Location
4. Perform washdown.
5. Dry the outside of the enclosure thoroughly before opening.
6. Open the label presentation chute cover (Figure 1-32) first to relieve any pressure or vacuum that might
be present.
7. Plug the printer back in after the washdown procedure is completed making sure that the power plug is
completely dry after washdown before inserting into a GFI rated outlet.
Warning
Main latches (one on
each side of enclosure)
Presentation chute cover
Mounting block