Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 23)

20 SST3 Installation Manual
Figure 3-1). Carefully unlatch the printhead assembly and disconnect the two cables from the printhead.
Figure 3-2. Remove Old Printhead Assembly
Replacement:
1. Reconnect the printhead cables.
2. Position the printhead on the printhead assembly and tighten the printhead mounting screw (do not
overtighten).
3. Clean the printhead.
4. Reload ribbon (if removed), lower the printhead assembly, and rotate the printhead latch back into
locked position.
Be sure to ground yourself to the chassis before you remove or install the printhead. This
prevents a static discharge from your body through the printhead to the ground.
Caution