1 general setup, 1 connecting the interface cable, Warning – Rice Lake SURVIVOR SST3 Washdown Printer User Manual
Page 5
2
SST3 Installation Manual
1.1
General Setup
When setting up the SST3 printer, ensure that the unit is firmly placed on a sturdy, horizontal work surface that
has sufficient work space around the perimeter of the unit. The unit opens towards the front so adequate space
must be made available to allow the user to safely lift the cover of the unit and change out labels as needed.
Because the cover opens to the front, counter depth only needs to accommodate the base footprint of the unit.
The cover does not rest on counter top when open.
Unit should sit on a sturdy surface when the cover is open to prevent tipping. This could
cause injury to the user.
The unit comes with an eight foot power cord. Use appropriate GFI outlet types for the
appropriate environment.
The SST3 printer must be installed near an easily accessible power outlet to allow for quick
disconnect in case of emergency.
Since unit will be used around water, use appropriate grounded outlets (GFI). Not doing so
could cause injury to the user.
1.1.1
Connecting the Interface Cable
The SST3 can be interfaced to a host device via Ethernet, Parallel, Serial and USB ports. Use the appropriate
cable for your application (not included).
Figure 1-1. Various Types of Interface Cables
Front of unit
Warning
Warning
Ethernet Network Cable
USB Cable
Parallel Port Cable
Serial Port Cable