Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 34)

Options 31
8. Set the heater into position onto the two threaded posts and using a 3/8” socket, tighten up the nuts to
secure the heater to the enclosure base.
Note: The heater kit comes with one nut as shown in Figure 5-3. Use the second nut which comes from the upper left
hand corner to secure the heater.
Figure 5-10. Secure Heater to Enclosure Bottom
9. Take the wire harness and match up the colors on the terminal strip block and the wire harness.
Figure 5-11. Color Match Wire Harness and Terminal Strip Wires
10. Connect the wire harness to the terminal strip block as shown.
Figure 5-12. Connect Wiring Harness to Terminal Strip
S e c o n d n u t n o t
shown in left hand
photo
BLK/ BROWN
WIRE
WHITE/BLUE
WIRE
G R E E N
GROUND