Torbal AGN100 - Manual (Page 11)

- 10 -
1. Carefully remove the scale, pan, and all of its components out of the
packaging and place them on a stable base where the scale will not
be affected by any mechanical vibrations or air movements.
2. AG Modes: After removing the pan base and the pan from their packaging, carefully install the pan
base onto the scale by seating it on the pan support located in the middle of the scale. Once the pan
base has been installed, carefully place the pan on the base as shown below.
AGN Models:
After removing the chamber base (4), draft
ring (3), pan base (2), and the pan (1) from
their packaging, carefully install the chamber
base (4) on the case of the balance as shown
below. Once the chamber base is in place,
install the draft ring (3). Once components 4
and 3 are in place install the pan base onto the
scale by placing it on the pan support located
in the middle of the scale. Once the pan base
has been installed, carefully place the pan on
the base as shown.
Chapter 5: Unpacking the Balance and Getting Started