Torbal AGN100 - Manual (Page 35)

- 34 -
4. To key in parameter data such as “unit id, user name, and project number”, make the desired selection
and press the right navigation key.
5. Once the right navigation key is pressed, use the scale’s alphabet or an external keyboard to key in the
required data. Press ENTER to accept and save.
8.3.2.2. Print Details
To configure Print Set Up follow the steps below.
1. Select “Print Details” from the Print Menu and press the ENTER key.
2. To enable or disable a desired printing detail use the navigation keys to make a desired selection and
press the ENTER key to place or remove a check-mark in order to enable or disable the desired detail.
8.3.3. Filter
The filtering function allows the user to perform weighing in an environment where the scale may be exposed to
drafts, frequent air movements, or vibrations. Lower Modes compensate for small disturbance and high modes
compensate large disturbances. To select an appropriate filtering mode follow the steps below:
1. From the Configuration Menu select “ Filter” and press the ENTER key.
2. Use the navigation keys to select “Status” and press the ENTER key.
3. Use the navigation keys to select a desired Mode and press the ENTER key to save the setting.