Torbal AGN100 - Manual (Page 15)

- 14 -
Main Menu is used to configure the scale and it’s weighing modes. Before entering the menu complete
and clear active functions by pressing the CLR key.
1. To enter the Main Menu press the MENU key. Once the MENU key is pressed the menu options will
be displayed.
8.1. Mode Setup
Torbal AG and AGN Scales can operate in ten application modes: Weighing, Parts Counting, Check
Counting, Percent Weighing, Totalizing, Compounding, Check Weighing, Animal Weighing, Display
Hold, and SQC Process Control. Before an application mode can be used it must be enabled and
configured. To use an application mode a quick key (Function keys F1 through F5) should be assigned
(recommended). Quick keys allow quick toggling between functions. By factory default the scale is in the
weighing mode. To enable other application modes follow the steps below.
1. From the Main Menu select “Mode Setup” and press the ENTER key. A list of available
applications and modes will be displayed.
Chapter 8: Main Menu