Torbal AGN100 - Manual (Page 52)

- 51 -
7. The display will indicate the numeric value of the sample. At any time add the remaining pieces to
perform check counting.
8. As check counting is performed the display will indicate the actual count. If the count is less than the
lower limit, the scale will display an “UNDER” command. If the count falls within the range, the
“ACCEPT”
command will be displayed. If the count exceeds the upper limit, the “OVER” command
will be displayed.
The value indicating the difference between the actual count and the target point is displayed in the
left upper corner of the display.
9. To begin a new check counting transaction, remove container and its content from the pan and press
the CLR key.