Torbal AGN100 - Manual (Page 23)

- 22 -
4. To configure the scale’s display during totalizing use the navigation keys to select “Display Setup”
and press the ENTER key. To disable information from displaying during the function use the
navigation keys to highlight the desired selection and press the ENTER key to remove the check mark.
Once the check mark has been removed the information will not display while performing totalizing.
5. To exit Totalizing set up use the navigation keys to select “Exit” and press ENTER.
8.1.6. Compounding
1. To configure the Compounding Function, use the navigation keys to select “Compounding” in “Mode
Setup” and press ENTER. The status and available Totalizing options will be displayed. If the function
is currently in use the status will be set to “ON”.
2. To enable Ingredient Labeling use the navigation keys to select “Ingredient Labeling” and press the
ENTER key. Use the navigation keys once again to enable or disable ingredient labeling. Once a
desired selection is made press the ENTER key.
3. To enable the Filling Gauge use the navigation keys to select “Filling Gauge” and press the ENTER
key. Use the navigation keys once again to enable or disable the filling gauge feature. Once the desired
selection is made press the ENTER key.
4. To enable or disable the Remaining to Fill feature use the navigation keys to select the ”Remaining to
Fill” and press the ENTER key. Use the navigation keys once again to enable or disable the remaining
to fill feature. One the desired selection is made press the ENTER key.