Torbal AGN100 - Manual (Page 21)

- 20 -
Percent Weighing Operating Modes
Automatic
When set to automatic the balance allows you to create a database of reference weights.
Each reference weight can be labeled with a unique name or an alpha numeric code and
stored in the scale’s internal memory along with its weight representing 100%. This
eliminates the need for establishing a new reference weights every time percent
weighing is performed.
Manual
When using Percent Weighing in manual the database feature is disabled and reference
weights are not stored in the scale’s memory. A reference weight equaling 100% must
be established every time Percent Weighing is performed.
3. To enable Reference Weight Labeling use the navigation keys to select “Reference Labeling” and
press the ENTER key. Use the navigation keys once again to enable or disable reference weight
labeling. Once a desired selection is made press the ENTER key.
“Reference Labeling” applies to the “Automatic Mode” only. It allows the user to assign a unique
name to a sample which is then stored in the scales database. When set to “OFF” the scale will not
assign or display names of the reference weights.
4. To assign a “Quick Key” use the navigation keys to select “Quick Key” and press the ENTER key.
Use the navigation keys to select a desired quick key (F1 through F5). Once the desired key is selected
press the ENTER key to accept the selection.
If the key is not available (used by a different function) a warning message will be displayed
“Warning Quick Key Already In Use!”
To override the key press ENTER. To abort and select a
different function key press the CLR key.
5. To configure the scale’s display during percent weighing use the navigation keys to select “Display
Setup” and press the ENTER key. To disable information from displaying during the function use the
navigation keys to highlight the desired selection and press the ENTER key to remove the check mark.
Once the check mark has been removed the information will not display while performing Percent
weighing.
6. To exit Percent Weighing set up use the navigation keys to select “Exit” and press ENTER.