Torbal AGN100 - Manual (Page 30)

- 29 -
2. To enable Limit Set Labeling use the navigation keys to select “Limit Set Labeling” and press the
ENTER key. Use the navigation keys once again to enable or disable limit set labeling. Once a desired
selection is made press the ENTER key.
“Limit Set Labeling” allows the user to assign a unique name to a Limit Set which is then stored in the
scales database. When set to “OFF” the scale will not assign or display names of the Limit Set.
3. To assign a “Quick Key” use the navigation keys to select “Quick Key” and press the ENTER key.
Use the navigation keys to select a desired quick key (F1 through F5). Once the desired key is selected
press the ENTER key to accept the selection.
If the key is not available (used by a different function) a warning message will be displayed
“Warning Quick Key Already In Use!”
To override the key press ENTER. To abort and select a
different function key press the CLR key.
4. To configure the scale’s display during SQC Process Control use the navigation keys to select
“Display Setup” and press the ENTER key. To disable information from displaying during the
function use the navigation keys to highlight the desired selection and press the ENTER key to remove
the check mark. Once the check mark has been removed the information will not display while
performing SQC Process Control.
5. To exit SQC Process Control set-up use the navigation keys to select “Exit” and press ENTER.