B&C Technologies SA Series Industrial User Manual
Page 28
OPERATING INSTRUCTIONS
4-6
types: Prewash, Wash, Rinse, Spin and Unroll (Shakeout). Each cycle can be assigned a number
between 1 and 99.
3.
Creation of Wash Programs (27)
Consists of putting the various cycles as programmed above together to form a complete wash
program. Up to 30 programs can be stored each with 15 cycles (segments).
Motor Programming
To access the motor programming mode, press START and RESET together. The display shows:
Enter 45 at this prompt, followed by the ENTER key. For two seconds, the display will show:
You are then asked to enter the motor routine number to be programmed (1 – 15).
You may now enter the number and press the ENTER key. There are now two cases:
1.
The motor routine does not exist.
2.
The motor routine does exist
NO. ?
* EDIT MOTORS *
MOTOR NO.