B&C Technologies SA Series Industrial - Manual (Page 35)

OPERATING INSTRUCTIONS
4-13
be selected from 30 to 93 degrees C.
Motor
For the motor function, after pressing ENTER, you are asked to enter a motor function. When you
have confirmed the selection with ENTER, the display shows:
Enter the desired value and press ENTER to confirm. In Prewash, Wash, Rinse, and Unroll, the
maximum speed is 100 RPM. Use Programming Code 207 to set maximum Spin RPM.
Programming Sequence for Prewash, Wash, Rinse and Unroll, the programming sequence is as
follows:
» Cooling
» Load Balanced (Temp Controlled Fill)
» Drain
» Cold Water
» Hot Water
» Heating
» Detergent 1
» Detergent 2
» Detergent 3
» Detergent 4
» Hard Water
» Relay 16 (Detergent 7)
» Relay 11 (Aux Fill)
» Relay 12 (Injection Flush)
» Relay 13 (Drive Balancing)
» Motor
» Relay 17 (Detergent6)
» Relay 18 (Not used)
» Relay 19 (Detergent 8)
» Relay 20 (Aux Drain)
» Relay 21 (Not Used)
» Relay 22 (Not Used)
» Relay 23 (Not Used)
» Relay 24 (Not Used)
RPM =