B&C Technologies SA Series Industrial - Manual (Page 37)

OPERATING INSTRUCTIONS
4-15
¾ The Program does not exist and must be created.
¾ The Program already exists and can be viewed and modified.
Creating a new Wash Program
The display reads.
For two seconds, then:
At this prompt, press ENTER. The display changes to:
Using the INC or DEC key, you can select the type of cycle to insert: Prewash, Wash, Spin, Rinse,
and Unroll. For example, if you wish to insert a wash cycle you have named 3; press INC until the
display changes to:
Confirm the selection by pressing ENTER. The display changes to:
Type 3 on the keypad, the press ENTER. Wash 3 is now stored as the first segment of the program.
The display will prompt you to enter a second cycle:
At this prompt, press ENTER. The choice of cycle will be displayed as previously. Programs can
be compiled with up to 15 cycles chosen from those in available in the cycles library. The same
cycle can be used repeatedly in a wash program. After you are through programming, and have
confirmed the last cycle, press STOP to terminate programming. The display then shows:
Press ENTER to store the program. Press RESET to cancel and return to the beginning if while
programming, you enter a wash cycle that does not exist, the following message will appear.
Since the wash cycle doesn’t exist, you will have to create it before adding it to a wash program.
NOT FOUND!
C1>?
C1>PREWASH = ?
C1>WASH = ?
C1>WASH = No.
C2>?
STORE?
NOT FOUND!