B&C Technologies SA Series Industrial - Manual (Page 41)

OPERATING INSTRUCTIONS
4-19
Single Step Execution
A single step or cycle of a wash program can be executed. At the main prompt, enter zero for the
program number. For two seconds, the display changes to:
Then, using the INC and DEC keys, you may choose the cycle you wish to run (PREWASH,
WASH, RINSE, SPIN, UNROLL). When you have selected you cycle, confirm by pressing
ENTER. The display changes to:
Pressing the START key will start the machine.
Partial Program
A program can be partially run. After selecting the program you wish to execute, the display will
show:
Instead of pressing ENTER to execute the program, press the ADVAN key. The cycles within the
program will be displayed incrementally. Choose the point at which you would like to begin, and
press the START key. The machine will begin operation from this point.
Displaying the Current Program and Step
While the machine is in operation, pressing then ENTER key will cause the display to show the
current program number and step.
Soak
You can insert a pause at any point of the wash program with the exception of distribution and spin.
To do so, simply press the PAUSE key. The display will begin showing a time, counting up as long
as the machine remains paused. Pressing the START key will restart the program at the point it was
paused. As long as the machine is paused, all other WDT (watch dog timers) are paused as well.
Advance
While any program is running, you can end the current step and advance to the next one by pressing
the ADVAN key. If the key is pressed during a spin, the spin will be aborted, and the standard spin
slow down time will be activated.
Halting a Program
At any time during the execution of the wash program, the running program can be terminated by
pressing the STOP key.
SINGLE CYCLE
RUN?
RUN?
PRG 1 STP 3