B&C Technologies SA Series Industrial - Manual (Page 36)

OPERATING INSTRUCTIONS
4-14
Editing an existing cycle
If the cycle you chose already exists, the display will show:
At this point, four choices are possible:
1. Choose another cycle by pressing STOP
2. Access the existing cycle by pressing ENTER. In this case, INC or DEC will display the
various segments, and the configuration can be modified by using the ENTER and RESET
keys as described in the previous section.
3. Insert one or more steps. To do so, scroll through the steps by using the ADVAN key. The
display will show START STEP 1 for two seconds, followed by ALREADY EXISTS! To
insert a step, press INS and to:
Followed by:
You may now proceed to program the new step using the techniques described earlier. After
confirming storage of the new steps, press STOP.
Remove one or more of the steps from the existing ones. Proceed by pressing ADVAN as describe
above in (3). When the message appears after the step you wish to remove,
Press the DEL key. The following message appears:
To confirm deletion of the step, press the ENTER key or press RESET to cancel the operation.
After confirmation, press the STOP key to exit.
Each cycle can comprise a maximum of 100steps. A total of 400 steps can be programmed.
Wash Program Creation
When the machine is stopped, press the START and RESET buttons together. The display is:
Using the keypad, type 27 and press ENTER. For two seconds, the display shows:
At this prompt, type the program number you wish to create or edit, followed by the ENTER key.
Again, two situations are possible:
ALREADY EXISTS!
START STEP 1
COOLING? NO
ALREADY EXISTS!
DELETE?
No. ?
EDIT PROG. No