B&C Technologies SA Series Industrial - Manual (Page 6)

IMPORTANT INFORMATION
1-2
Before machine is placed in operation, the door safety interlock must be checked for proper
operation as follows:
A. When the washer is energized electrically and in operation, the loading door must be locked in
the closed position. Verify this by attempting to open the loading door when the machine is
operating. If necessary, check the door safety interlock and sensors for proper operation.
Consult the service manual, or call a qualified service technician if necessary.
B. When the washers loading door is open, it should not be possible to start the machine. Verify
this by attempting to start the washer with the door open. Also, close the door without locking
it and verify that it is not possible to start the machine with the door not locked. If necessary,
check the door lock sensors for proper operation. Consult the service manual, or call a
qualified service technician. If additional information is required, contact your local distributor
or call the manufacturer of the machine
Before servicing any equipment, make certain it is disconnected from the
electrical power source. Never allow operation of the machine when any safety
device is malfunctioning. Never bypass safety devices.
To provide personal safety and keep the machine in proper working order, follow all
maintenance and safety procedures presented in this manual. If questions regarding safety arise.
Contact the factory immediately.
Use factory authorized spare parts to avoid safety hazards.
Operator safety
Never insert hands or objects into basket until it has completely stopped. Doing
so could result in serious injury.
To ensure the safety of machine operators the following maintenance checks must be
performed daily.
1.
Prior to operating the machine, verify that all warning signs are present and legible. Missing or
illegible signs must be replaced immediately. Make certain that spares are available.
2. Check door interlock before starting operation of the machine, see safety checklist.
3. Do not attempt to operate the machine if any of the flowing conditions are present.
3.1 The door does not remain securely locked during the entire cycle.
3.2 Excessively high water level is evident.
3.3 Machine is not connected to a properly grounded circuit.
Do not bypass any safety devices in the machine.
Never operate the machine with a bypassed or disconnected out – of – balance
switch. Operating the machine with severe out – of – balance loads could result
in personal injury and serious equipment damage.