B&C Technologies SA Series Industrial User Manual
Page 56
MAINTENANCE
5-3
adjusting bolts and adjusting the belts to the proper tension. Then the bolts should be
tightened. See figure.
c.
Verify that V – belts are properly aligned by checking pulley alignment. Place a straight
edge across both pulley faces. The straight edge should make contact with pulleys in four
places. See figure.
Figure.5-1 Straight edge the V – belt
5.
Remove back panel and check overflow hose and drain hose for leaks.
6.
Unlock the hinged lid and check the supply dispenser hoses and hose connections.
7.
Clean inlet hose filter screen:
a.
Turn water off and allow valve to cool, if necessary.
b.
Unscrew inlet hose and remove filter screen.
c.
Clean with compressed air and reinstall. Replace if worn or damage.
8.
Tighten motor mounting bolt lock nuts and bearing bolt lock nuts, if necessary.
9.
Use compressed air to clean lint from motor.
10. Clean external water and steam filters.
Quarterly
NOTE:
Disconnect power to the machine before performing the quarterly maintenance
procedures.
1.
Tighten door hinges and fasteners, if necessary.
2.
Tighten anchor bolts, if necessary.
3.
Check all painted surfaces for bare metal (matching paint is available from the manufacturer.)