B&C Technologies SA Series Industrial - Manual (Page 29)

OPERATING INSTRUCTIONS
4-7
New motor routine
In this case, you are prompted to enter a clockwise rotation time with this message:
Enter the desired time in seconds, followed by the ENTER key. The display will change
Enter the desired time in seconds, followed by the ENTER key. The display will change
Enter the counterclockwise time in seconds, followed by the ENTER key. The display will show:
Pressing ENTER will store the motor timing routine and the display will change to request a new
access code:
Enter 45 at the prompt to program additional motor timing sequences as required. Pressing RESET
instead of ENTER will exit programming.
Editing an Existing Routine
If the motor routine number you entered id already present, the display will show:
Pressing the ENTER key again displays the forward rotation time:
Pressing the INC and DEC keys allow you to step through the values for Forward, Pause, and
Backwards. Pressing ENTER will allow you to modify the value on the display
After having viewed or modified the backwards value, pressing the INC or ENTER key displays:
Pressing ENTER confirms the changes mode (if any) and exits programming. Pressing RESET
exits the current programming mode and leaves the existing values as they were.
T. FORWARD = S
T. PAUSE = S
T. BACKWARDS = S
STORE?
NO. ?
ALREADY EXISTS!
T. FORWARD = XXs
STORE?