B&C Technologies SA Series Industrial User Manual
Page 54
MAINTENANCE
5-1
SECTION 5
MAINTENANCE
Routine Maintenance
Routine maintenance maximizes operating efficiency and minimizes downtime. The
maintenance procedures described below will prolong the life of the machine and help prevent
accidents.
Daily, weekly, monthly, and quarterly checklists are provided at the end of this section.
Laminate the checklists to preserve them for repeated copying. Operators and technicians are
encouraged to add checks specific to their machine’s particular application. When possible, space is
provided on the checklists for this purpose.
The following maintenance procedures must be performed regularly at the required
intervals.
Install all panels that are removed to perform service and maintenance
procedures. Do not operate the machine with missing guards or with broken or
missing parts. Do not bypass any safety devices!
Daily
1.
Inspect water inlet valve hose connections on the back of the machine for leaks.
2.
Inspect steam hose connections for leaks, where applicable.
3.
Verify that insulation is intact on all external wires and that all connections are secured. If bare
wire is evident, call a service technician.
4.
Check door interlock before starting operation:
a.
Attempt to start the washer with the door open. The washer should not start with the door
open.
b.
Close the door without locking it and attempt to start the machine. The machine should
not start with the door open.
c.
Close and lock the door and start a cycle. Attempt to open the door while the cycle is in
progress. The door should not open. If manual latch is moved out of position the machine
should stop.
If the door lock and interlock are not functioning properly, call a service technician.
End of the day
1.
Clean the door gasket of residual detergent and foreign matters.
2.
Clean the automatic supply dispenser and the lid inside and out with mild detergent. Rinse with
clean water.
3.
Clean the washer’s top, front and side panels with mild detergent. Rinse with clean water.
4.
Leave loading door open at the end of each day to allow moisture to evaporate.
A. THE MACHINE MAINTENANCE