B&C Technologies SA Series Industrial - Manual (Page 32)

OPERATING INSTRUCTIONS
4-10
Cycle Programming
Cycle libraries can be created for later use in the wash programming step. When the machine is
stopped, press the START and RESET buttons together. The display is:
Using the keypad, type 12 and press ENTER. For two seconds, the display shows:
The message for choosing the programming cycle is then displayed:
Pressing INC or DEC will show the other cycle types in succession:
When the cycle type you wish to edit is displayed, press ENTER to begin creating or editing of the
cycle. As an example, we will go through programming a prewash cycle.
Using the numerical keypad, enter the cycle you wish to create or modify. After you have entered
the number and pressed ENTER, there are two possible cases:
New Cycle Creation
If the cycle you chose does not exits, you will be taken directly into the programming mode. For
two seconds, the display will show:
The display then changes to:
You can now define for step 1 whether the cool down feature is activated. If you wish to activate
cool down, press ENTER, and the display changes to:
No. ?
* EDIT CYCLES *
PREWASH = ?
WASH = ?
SPIN = ?
RINSE = ?
UNROLL = ?
PREWASH = ?
START STEP 1
COOLING? NO
COOLING? YES