B&C Technologies SA Series Industrial - Manual (Page 38)

OPERATING INSTRUCTIONS
4-16
Editing an Existing Program
In the event the wash program already exists, the display will change to:
For two seconds, followed by the display of the program contents. For example:
By using the INC or DEC keys, the various cycles comprising the wash program can be viewed.
The program can be modified, and cycles can be added or deleted.
Deleting a Cycle
Using the INC and DEC keys, find the cycle you wish to delete. While the cycle is displayed, press
the delete key, and then press the STOP key when the display changes to:
Confirm by pressing the ENTER key. The cycle in question will be deleted, and the cycles
following will be decremented by one.
Inserting a Cycle
To insert a cycle, use the INC and DEC keys to find the cycle that will follow the cycle you are
about to insert. The new cycle will be inserted just before the cycle displayed. Now press the INS
key, the request to enter a new cycle will be displayed:
Press ENTER to confirm that you wish to insert a new cycle:
Use the INC and DEC keys to reach the required cycle and press ENTER to confirm. You will
then be asked to enter the cycle number:
After entering the cycle number and pressing the ENTER key, you can leave programming by
pressing STOP. The display changes to:
Press the ENTER key to store the altered program. All the following cycles will be incremented by
one. If you don’t want to change the program, press the RESET key rather than the ENTER key.
This will cancel all modifications made.
ALREADY EXISTS!
C1>RINSE = 1
STORE?
STORE?
C->?
Cn> PREWASH=?
Cn> PREWASH=No.?
STORE?