B&C Technologies SA Series Industrial - Manual (Page 7)

IMPORTANT INFORMATION
1-3
Safe Operation Environment
Safe operation requires an appropriate operating environment for both the operator and the
machine. If questions regarding safety arise, contact the factory.
Environmental Conditions
1. Ambient temperature.
Water in the machine will freeze at temperatures of 32 ºF (0 ºC) or below. Temperatures above
120 ºF (50 ºC) will result in more frequent motor overheating and, in some cases, malfunction or
premature damage to solid state devices that are used in the machines. Special cooling devices may
be necessary.
2. Humidity.
Relative humidity above 90% may cause the machine’s electronics or motors to malfunction or
may trip the ground fault interrupter. Corrosion problems may occur on some metal components.
If the relative humidity is below 30% belts and rubber hoses may eventually develop dry rot. This
condition can result in hose leaks, which may cause hazards external to the machine in conjunction
with adjacent electrical equipment.
3. Ventilation.
The need for make – up air openings for such laundry room accessories as dryers, ironers,
water heaters, etc. must be evaluated periodically. Louvers, screens, or other separating devices
may reduce the available air opening significantly.
4. Radio Frequency Emissions.
A filter is available for machines in installations where floor space is shared with equipment
sensitive to radio frequency emissions. All machined that are shipped to CE countries are equipped
with this filter and comply with the EMI regulations.
5. Elevation.
If the machine is to be operated at elevations over 3280 feet (100 meter) above sea level, pay
special attention to water levels and electronic settings (particularly temperature) or desired result
may not be achieved.
6. Chemicals.
Keep stainless steel surfaces free of chemical residues to avoid corrosion.
7. Water damage.
Do not spray the machine with water. Short circuiting and serious damage may result. Repair
immediately all seepage due to faulty gaskets, etc.
Do not place volatile or flammable fluids in any machine. Do not clean the
machine with volatile or flammable fluids such as acetone, lacquer thinners,
enamel reducers, carbon tetrachloride, carbon tetrachloride, gasoline, benzene,
naphtha, etc. Doing so could result in serious personal injury and / or damage to
the machine.