B&C Technologies SA Series Industrial - Manual (Page 61)

TROUBLE SHOOTING
7-1
SECTION 7
TROUBLE SHOOTING
Before Proceeding with Troubleshooting
WARNING
If any of the protective functions have been activated, first remove the cause. Then, after
checking that the all run commands are set to off, reset the alarm. Note that if the alarm is reset
while any run commands are set to on, the inverter any supply the power to the motor which may
cause the motor to rotate.
Injury may occur.
- Even though the inverter has interrupted power to the motor, if the voltage is applied to
the main circuit power input terminals L1/R, L2/S and L3/T (L1/L and L2/N for single – phase
voltage input), voltage may be output to inverter output terminals U, V, and W.
- Some electric charge may remain in the DC bus capacitor even after the power is turned
off. Therefore, it may take some time until the DC link circuit voltage reaches a safe level. Before
touching the circuit, wait for at least five minutes after the power has been turned off and check that
the DC voltage between main circuit terminals P (+) and N (-) is less than +25 VDC using a
multimeter.
Electric shock may occur.
Follow the procedure below to solve problems.
1. First, check that the inverter is correctly wired, referring “Wiring for Main Circuit Terminals
and Grounding Terminals”
2. Check whether an alarm code is displayed on the LED monitor.
- If no alarm code appears on the LED monitor
- If an alarm code appears on the LED monitor
If any problems persist after the above recovery procedure, contact the shop where
you bought the inverter or your local Fuji branch office.